Logo
Raja72 Ali
6 months ago
Mere pass Cnc trunning siemens control 808 d h Use program krna h
Koi bata sakta h
cnccode
Zaroor! Siemens 808D CNC control system ka use karke program likhna kuch steps mein hota hai. Yahan main kuch basic steps bata raha hoon, lekin aapko apne specific machine ke manuals aur Siemens 808D programming guide ko bhi refer karna chahiye:

1. **Programming Language:**
Siemens 808D control system usually supports G-code programming. G-code is a standardized programming language used in CNC machining.

2. **Create a Program:**
Apne gear ke design ke hisab se ek program likhein. Ismein aapko toolpaths, speeds, feeds, aur anya machining parameters specify karna hoga.

3. **Tool Selection:**
Har tool ke liye appropriate tool number aur parameters set karein. Ye include karein tool diameter, cutting speeds, aur feed rates.

4. **Workpiece Setup:**
Workpiece dimensions aur zero points set karein. Ye aapke gear ke design ke hisab se hoga.

5. **Zero Reference Point:**
CNC machine par zero reference point set karein. Ye aapke workpiece ke kisi specific point ko reference point ke roop mein use karta hai.

6. **Tool Change:**
Agar aap multiple tools use kar rahe hain, to program mein tool change commands add karein.

7. **Simulation:**
Pehle, ek simulation run karein ***** ein machine sirf simulate hoti hai aur actual cutting nahi hoti. Isse aap errors ko pehchan sakte hain.

8. **Load the Program:**
Apna program CNC machine mein load karein. Iske liye aapko machine ke interface ka use karna hoga.

9. **Run the Program:**
Program ko run karein. Dhyan rahe ki aap pehle ek test run karein taki aap sure ho sakein ki sab kuch sahi tarah se ho raha hai.

10. **Monitoring:**
Process ke dauran machine ko monitor karte rahein. Agar koi problem aaye, to turant use address karein.

Ye steps general guidance hain, aur aapke specific machine aur design ke hisab se alag ho sakte hain. Hamesha machine aur software ke manuals ka use karein aur training lein jisse aapko sahi guidance mile.
6 months ago
In response Raja72 Ali to his Publication
Raja72 Ali
6 months ago
In response cnccode to his Publication
Thanx sir pr mujhe n cycle me kaise dalna h samjh nhi aa raha h